# Krescue boot NOTE: all VIMs devices have unique uboot, plz write proper Krescue image for your device ## krescue boot from SD ### VIM3 VIM3L #### Android default firmware + unplug usb cable + insert SD card with Krescue + press and hold POWER_KEY + plug usb cable and wait LED blinking after u can unpress POWER_KEY + ok Krescye system bootup from SD #### VIM3 VIM3L usb otg NOTE same as previous , but usb plug in host machine need plug usb cable in two steps on host side + power without data pin connection - just slowly plug about 1/3 length usb header - before powerup + wait blinking leds and plug usb cable for full length for activate data pins ### eMMC is cleared + start from sd without special preparation ### multiboot instaled + start from sd without special preparation ### VIM1.v14 new version and VIM2 + triple press middle KEY_F ### VIM1 old version + mask rom mode